#Troubleshooting# Fail to run health check for IAG
  

Sangfor_52795 Lv1Posted 09 Oct 2024 17:55

Last edited by Sangfor_52795 15 Oct 2024 19:20.

Q1:SangforChecks supports health check versions
Versions above 11.0


Q2:The IAG device cannot be health - checked normally
2.1 Issue Description
1. According to the User Manual, the IAG device cannot be health - checked normally.
2.2 Solution
1.  Configure the device according to the following.
a)  Log in to the IAG console, go to System > General > Advanced, and click Remote Tech Support. Then, select Enable admin access via LAN/DMZ interface for Update and click Enable Firmware Updater, as shown in the following figure.

b)  Configure the Task settings and click Start, as shown in the following figure.

3.  Check whether the port connectivity is normal. (443 and 51111)


4.  Try clicking Start directly. If an error is still prompted, click Continue to continue trying.

5.  If the inspection is still abnormal, please contact tech.support@sangfor.com.

Like this topic? Like it or reward the author.

Creating a topic earns you 5 coins. A featured or excellent topic earns you more coins. What is Coin?

Enter your mobile phone number and company name for better service. Go

Enrico Vanzetto Lv4Posted 10 Oct 2024 17:19
  
Hi, thanks for sharing.

Trending Topics

Board Leaders