How can I connect LACP to the internet? NGAF v8.0.35 and v8.0.47

Ian_ Lv1Posted 2025-Jan-30 11:59

I already configured my 2 ports (eth2 & eth3). It has internet when I test each port but when I created the link aggregation to LACP (active). I cannot connect to the internet.

How can I configure the LACP to connect to the internet?

My configuration:
Aggregate interface

NAT:

app control:
network object:

physical interface:


This topic contains more resources

You must log in to download or view the file. Not registered yet? Register

x

By solving this question, you may help 822 user(s).

Posting a reply earns you 2 coins. An accepted reply earns you 20 coins and another 10 coins for replying within 10 minutes. (Expired) What is Coin?

Enter your mobile phone number and company name for better service. Go

pmateus Lv3Posted 2025-Jan-30 16:53
  
HI,
From you pictures, it looks like that your link aggregation is not going up. You need to configure to LACP from the other side where the 2 interfaces are connected.

Hope this can help.Thanks,
Enrico Vanzetto Lv4Posted 2025-Jan-31 00:38
  
Hi,which model is your switch? your firewall is connected to a switch that supports LACP? if yes, try setting up on switch side two ports with Dynamic LACP and connect only one port to firewall (to prevent spanning tree port block). After that, connect second port to firewall and see on switch logs if there's some alert about spanning tree .

I Can Help:

Change

Moderator on This Board

11
8
5

Started Topics

Followers

Follow

1
3
6

Started Topics

Followers

Follow

0
4
5

Started Topics

Followers

Follow

67
20
3

Started Topics

Followers

Follow

3
15
3

Started Topics

Followers

Follow

1
140
3

Started Topics

Followers

Follow

Board Leaders