aSan Networking

Parwita Lv1Posted 08 Jan 2019 09:46

Hi Team, i plan to configure only 2 nodes and the storage will use 10G.
If i want to directly connect for storage to each other host without switch, wich link aggregation mode should i select since directly connect don't use any switch.  

CTI SC has solved this question and earned 20 coins.

Posting a reply earns you 2 coins. An accepted reply earns you 20 coins and another 10 coins for replying within 10 minutes. (Expired) What is Coin?

Enter your mobile phone number and company name for better service. Go

(In reply to Parwita)
Hi!
Yes. link aggregation disable is used for the deployment recommended for two nodes connect without switch.

The IP address can used the IP address that can let both nodes able to communicate.
for example After select the corresponding eth interface, Node 1 configured as 10.251.251.251/24 and node 2 configured as 10.251.251.252/24.
Is this answer helpful?
CTI SC Lv2Posted 08 Jan 2019 14:29
  
Hi! Parwita.
Kindly use the link aggregation disabled if you not using any switch.

I Can Help:

Change

Moderator on This Board

2
1
0

Started Topics

Followers

Follow

11
7
5

Started Topics

Followers

Follow

3
14
3

Started Topics

Followers

Follow

2
2
0

Started Topics

Followers

Follow

Board Leaders