Please Help i can't cancel Task

Newbie829978 Lv1Posted 11 Sep 2019 12:06

Dear Support

I want to Update Firmware On HCI V. 5.8.7. But I have Some Problem On Process. this message " Some virtual storage task is running. Please wait until it is completed. and then try again. "   than we can't Cancel this task.
We troubleshooting this problem. I see the  physical disk in storage  processing On node 1 simultaneously with task so long time always.


PLEASE CONTACT ME DIRECTLY.
THANK IN ADVANCED.

1.JPG (68.4 KB, Downloads: 994)

1.JPG

2.JPG (28.04 KB, Downloads: 998)

2.JPG

3.JPG (14.1 KB, Downloads: 990)

3.JPG

1.JPG (68.4 KB, Downloads: 1004)

1.JPG

2.JPG (28.04 KB, Downloads: 989)

2.JPG

3.JPG (14.1 KB, Downloads: 983)

3.JPG

OMO has solved this question and earned 10 coins.

Posting a reply earns you 2 coins. An accepted reply earns you 20 coins and another 10 coins for replying within 10 minutes. (Expired) What is Coin?

Enter your mobile phone number and company name for better service. Go

please wait. because it is adjusting the data on virtual storage . If very long Let the disk check may be broken.
I have encountered this problem.  ^^
Is this answer helpful?
OMO Lv1Posted 24 Sep 2019 11:34
  
please wait. because it is adjusting the data on virtual storage . If very long Let the disk check may be broken.
I have encountered this problem.  ^^
ITD_Mitch Lv3Posted 25 Sep 2019 22:34
  
Hi.. is it solved already?
Faisal P Posted 30 May 2022 10:53
  
You required to download Sangfor Firmware update to proceed
rivsy Lv5Posted 30 May 2022 11:54
  
It is recommended when upgrading firmware that you update it 1 version higher not 2 to 3 version higher (example if your firmware is version 6, then you want to upgrade to version 8, you must upgrade to version 7 first before going to version 8).  

And check the following condition if meet:
1. Check if the upgrade license is valid
2. Check if the NGAF deployed in HA (High Availability mode) is disabled (enable this after upgrade)
3. Check if the custom patch or KB patch installed on the NGAF
4. Check if the NGAF hardware can support the firmware
5. Check in the Sync Options if the synchronization is disable
jetjetd Lv5Posted 03 Jun 2022 19:00
  
Can you let finish the virtual storage task? If it takes very long already maybe there is some issue with the disks itself.
regidorreyes Lv5Posted 03 Jun 2022 19:07
  
You must let it finish the virtual storage task. Just be patient and if the disk has a problem, it will notify that events.

I Can Help:

Change

Moderator on This Board

2
1
0

Started Topics

Followers

Follow

11
7
5

Started Topics

Followers

Follow

3
14
3

Started Topics

Followers

Follow

2
2
0

Started Topics

Followers

Follow

Board Leaders