Double Bridge Mode For Redundant Link

Ajep Almurnando Lv1Posted 19 May 2021 15:04

Hi There,

Please help, I'm implement WANO using Double Bridge mode, I need to configure traffic using two ISP for Failover traffic. The goals is if one ISP get down I have backup link.

Commonly I'm implement link Failover in router using link monitor check, usually using ping test to PTP. But, I'm not sure what is trigger on WANO when one of ISP down, the traffic will move to another link.

I can't find guide for this configuration.

Thanks,

Liew has solved this question and earned 10 coins.

Posting a reply earns you 2 coins. An accepted reply earns you 20 coins and another 10 coins for replying within 10 minutes. (Expired) What is Coin?

Enter your mobile phone number and company name for better service. Go

Last edited by Liew 01 Jul 2021 14:14.

Hi Ajep Almurnando, you may enable propagate link down option in HA active standby environment. This option can find under system> network> deployment. It will detect whether the interface is down. If yes, the pair bridge interface will down failover to another link.
Is this answer helpful?
Liew Lv2Posted 01 Jul 2021 10:08
  
Last edited by Liew 01 Jul 2021 14:14.

Hi Ajep Almurnando, you may enable propagate link down option in HA active standby environment. This option can find under system> network> deployment. It will detect whether the interface is down. If yes, the pair bridge interface will down failover to another link.

I Can Help:

Change

Board Leaders