How configure LDAP or sync LDAP server in Sangfor IAG device.
  

Newbie781358 Lv1Posted 18 May 2023 12:32

Hi Concern,

Please guide me for how I can configure LDAP server in Sangfor IAG.
Faisal Piliang Posted 21 May 2023 10:14
  
Hi,

Follow these step:
1. Add a new LDAP Server under the External Auth Server.
2. Enter the details such as Server Name, IP Address of the external authentication server, the admin account username and password and select the BaseDN. After entered all the details, click the Test Validity to check whether able to connect the external authentication server or not.
3. After tested the validity, a message will prompt out to show the result.
4. Click the Sync with all LDAP servers to sync all the data.
   
   Now, the configuration is successfully set.

Thanks
Farina Ahmed Lv5Posted 22 May 2023 14:52
  
To configure an LDAP server in Sangfor IAG (Internet Access Gateway), you can follow these general steps:

Log in to the Sangfor IAG device's management interface.

Navigate to the LDAP configuration section or menu.

Specify the LDAP server settings, including the server address (IP or hostname) and port number.

Provide the appropriate credentials for authenticating with the LDAP server, such as a username and password.

Configure the LDAP search base DN (Distinguished Name), which is the starting point for the LDAP search.

Define the LDAP filter to specify the criteria for user authentication. This filter determines which user attributes will be used for authentication, such as username, email, or group membership.

Set the LDAP connection timeout and retry options according to your requirements.

Test the LDAP server connection to verify that the Sangfor IAG device can successfully communicate with the LDAP server.

Save the configuration changes.

It's important to note that the specific configuration steps may vary depending on the firmware version and interface of your Sangfor IAG device