RegiBoy Lv5Posted 21 Jun 2023 16:50
  
You can connect them point to point
noime Lv3Posted 21 Jun 2023 16:51
  
Configure the network settings on each server's operating system to match the assigned IP addresses and subnets.
NeTSec Lv3Posted 21 Jun 2023 16:52
  
Assign IP addresses to the Ethernet interfaces on both servers. Make sure to use a separate subnet for each pair of connected interfaces. For example, you can use the 192.168.1.0/30 subnet for one pair, 192.168.2.0/30 for another pair, and so on. Adjust the subnet mask accordingly for each subnet.
Naomi Posted 21 Jun 2023 16:54
  
Ping each node from the other to ensure they can communicate successfully. Additionally, perform performance tests to validate the network's stability and throughput.
MISMIS Lv3Posted 21 Jun 2023 16:54
  
Connect Ethernet ports on both servers directly to each other using Ethernet cables
isabelita Lv3Posted 21 Jun 2023 16:56
  
Set up a dedicated storage network: Since HCI involves shared storage, it's recommended to have a dedicated network for storage traffic.
Newbie451055 Lv2Posted 23 Jun 2023 18:11
  
For 2 nodes deployment you can directly connect for storage network and overlay network.
But these nodes have to communicate to the network, in order to be managed and connect to the gateway.
For this purpose you need to connect minimum 2 Ethernets from each node (1 for management network and 1 for edge network) to your LAN.
Management network is for remote the server and edge network utilize by the VM to connect to your LAN.
CTI TF Lv2Posted 11 Jul 2023 10:39
  
Hi. You will need to have at least 1 network switch for HCI management and edge interface to connect.
The best practice in your case will be as follow:
1. Management Interface - Create aggregation and connect to network switch.
2. Overlay Interface - Direct connect between the nodes.
3. Storage Interface - Direct connect between the nodes with aggregation.
4. Edge Interface - Can either reuse the aggregation for management interface or use the remaining interface and connect to network switch.

I Can Help:

Change

Moderator on This Board

2
1
0

Started Topics

Followers

Follow

11
7
5

Started Topics

Followers

Follow

3
14
3

Started Topics

Followers

Follow

2
2
0

Started Topics

Followers

Follow

Board Leaders