Allow only emails

How to allow only emails sites through Sangfor NGAF,  I allowed only email category in Policies, Application control, to an object, but some emails server working some not,
any solution so all emails like gmail, yahoo, hotmail and all other pop, smtp allowed.

if i allowed SSL category then all working but in this sanario some website are also allowed, i want to block all site and allow only emails.

Go to > Policies > Access Control > Application Control > Application > Mail > set and select the mail server you are using in your organization

Only select "Mail"

Then check the preferred mail settings

hi rivsy,

already done this but some email sites working some not.

Go to > Policies > Access Control > Application Control > Application > Mail > and get the email server you desired

Go to > Policies > Access Control > Application Control > Application > Mail > set and select the mail server you are using in your organization

To allow only email sites through Sangfor NGAF, you can follow these steps:

1- Log in to the Sangfor NGAF web console using your administrative credentials.
2- Navigate to the "Security Policy" section and select "Access Control".
3- Create a new access control policy by clicking on the "Add" button.
4- Name the policy and select "HTTP/HTTPS" as the service type.
5- Under "Source Address", select the range of IP addresses that you want to apply the policy to.
6- Under "Destination Address", enter the domain names of the email sites that you want to allow (e.g., gmail.com, yahoo.com, etc.).
7- Under "Action", select "Allow".
8- Save the policy by clicking on the "Save" button.

This policy will allow traffic from the specified source IP addresses to access only the email sites that you have specified, while blocking all other traffic.

Create a new access control policy, Under "Action", select "Allow".

I think it does not supported

Follow the below steps:

1. Go to > Policies > Access Control > Application Control > Application > Mail > and get the email server you desired

Copy Code

Navigate to the "Security Policy" section and select "Access Control".