mdamores Lv3Posted 30 Apr 2024 15:08
  
Hi,

There are several ways to configure 2 WAN links on Sangfor IAM.

1. Link State detection
   - login to Sangfor IAM web interface and go to Network > Interface > WAN Link
   - Click the link stte detection settings for each WAN link (usually at the bottom of the page), Enable the link state detection.
   - You may try to monitor the health using PING
   - configure and set the destination IP address of the link using the IP Gateway of the ISP and click Commit to save the changes.

2. Failover policy
   - go to Bandwidth Management > Link Load Balancing and click "Enable link load balancing policy".
   - confirm that the line state detection you configured will show "Normal" status for both links

I Can Help:

Change

Moderator on This Board

15
21
3

Started Topics

Followers

Follow

Board Leaders