CPU and Memory always High

Yuniar Ashurin Lv1Posted 2023-Nov-22 11:16

I have a problem with the NGAF device why is the CPU and Memory always High and above 60% for CPU and memory usage? How to utilize CPU and Memory usage for Sangfor NGAF?

Newbie517762 has solved this question and earned 20 coins.

Posting a reply earns you 2 coins. An accepted reply earns you 20 coins and another 10 coins for replying within 10 minutes. (Expired) What is Coin?

Enter your mobile phone number and company name for better service. Go

HiHi,

Below refers to the NGAF 8.0.47 User manual regarding the CPU, memory & disk being high for a long time(p627).

10.1.3 Checking the Running Condition of the Device:

Check whether the usage ratio of the CPU, memory, and disk is high for a long time according to the system status on the device console.
If so, follow the steps below:

1. Choose Home > Network Operations > Throughput and check whether the current bandwidth is in full load all the time.

2. Choose Home > Network Operations > Concurrent Session/New Session and check whether the emergency concurrent sessions or new sessions are generated.

3. Enable the anti-DoS attack module for the device and check whether the device is suffering from DoS attacks. Choose Monitoring > Logs > Security Logs to view the anti-DoS attack logs.

4. Check whether any process runs abnormally.
(Contact the technical support engineer from Sangfor for confirmation.)
Is this answer helpful?
Newbie517762 Lv5Posted 2023-Nov-22 14:50
  
HiHi,

Below refers to the NGAF 8.0.47 User manual regarding the CPU, memory & disk being high for a long time(p627).

10.1.3 Checking the Running Condition of the Device:

Check whether the usage ratio of the CPU, memory, and disk is high for a long time according to the system status on the device console.
If so, follow the steps below:

1. Choose Home > Network Operations > Throughput and check whether the current bandwidth is in full load all the time.

2. Choose Home > Network Operations > Concurrent Session/New Session and check whether the emergency concurrent sessions or new sessions are generated.

3. Enable the anti-DoS attack module for the device and check whether the device is suffering from DoS attacks. Choose Monitoring > Logs > Security Logs to view the anti-DoS attack logs.

4. Check whether any process runs abnormally.
(Contact the technical support engineer from Sangfor for confirmation.)

I Can Help:

Change

Moderator on This Board

11
8
5

Started Topics

Followers

Follow

1
3
5

Started Topics

Followers

Follow

0
4
5

Started Topics

Followers

Follow

67
20
3

Started Topics

Followers

Follow

3
14
3

Started Topics

Followers

Follow

1
138
3

Started Topics

Followers

Follow

Board Leaders